3
Important Information
m
Caution!
Setting up and mounting this appliance requires
extensive expertise in various trades (mechanics,
carpentry, plumbing, electrics).
It is the duty of the person setting the appliance up to
guarantee that it is set up and commissioned securely.
Mistakes in setting the appliance up and damage
resulting from this do not come under the warranty
of the manufacturer. Terms of guarantee are found
in the operating instructions of the appliances.
m
Warning!
The appliances are very heavy and must be secured from
tipping when transporting, when mounting and when
operating. It is absolutely necessary to fit an anti-tip device.
Keep the doors closed until the appliance has been
mounted completely and secured according to the
instructions in these mounting instructions.
Because of the weight / dimensions of the appliance and
to minimise the risk of injuries and damage to the appliance
at least two persons are necessary to set-up the appliance
securely.
Use the appliances according to the prescribed
application.
Pull out the plug or remove the fuse before commencing
work on the appliance.
Only allow a specialist electrician to exchange a mains lead.
Only allow customer service to carry out repairs to the
appliance.
Apart from statutory national regulations, you should stick
to the connection terms relating to the local electricity and
water companies.
These mounting instructions are designed to help you
install your new appliance.
The manufacturer cannot be held liable for mounting which
has been improperly carried out. We recommend that you
allow a qualified specialist to set up and switch the
appliance on for the first time.
Following all information and keeping to the instructions are
preconditions for mounting and switching the appliance on
safely for the first time.
Keep the mounting instructions safe for use later on.
Before setting up and switching the appliance on for
the first time, read the mounting instructions fully and
thoroughly.
Installation Possibilities
Various installation possibilities are available.
These are only limited by the kitchen design and the finger
protection function.
Stand alone appliance
Stand alone appliance with dividing wall
Note:
–
When measuring the dividing wall for model 2,
pay attention to the thickness of the furniture front to
be mounted in order to avoid damage when opening
doors at the same time.
–
If the distance between the appliances is less
than 160 mm, the heating kit for the side-by-side
combination should be used.
For further information see section “Additional
acessories” on page 9.
–
The minimum thickness of the dividing walls is 16 mm.
As an end section to a row of kitchen
units
If a side of the appliance is visible, use a side covering.
The side covering must be connected firmly to the wall,
the floor and the upper cupboards before the appliance is
slid into the installation niche.
The dimensions of the side covering are governed by the
opposing niche wall. During installation, make sure that the
installation niche has right angles and has the exact size
necessary for the appliance.