en
Before using for the first time
6
Controls
Use the remote control to set all of the functions of
your appliance.
Tip:
Align the remote control as precisely as possible
to the infrared receiver for the LED display.
Switch the appliance on or off
Switch on automatic mode
1
Increase the fan setting
Decrease the fan setting
Switch the lighting on or off
Reduce the brightness
Increase the brightness
Switch the fan run-on on or off
Switch Home Connect on or off
Reset the filter saturation indicator
1
Depending on the appliance specifications
LED display
Die LED-Anzeige zeigt eingestellte Werte und Funk-
tionen.
8
1
2
3
4
5
6
7
1
Fan setting 1/grease filter saturation display
2
Fan setting 2/odour filter saturation indicator
3
Fan setting 3
4
Intensive mode 1
5
Intensive mode 2
6
Automatic mode
1
/fan run-on time/interval vent-
ilation
7
Home Connect
1
Depending on the appliance specifications
8
Infrared receiver
1
Depending on the appliance specifications
Before using for the first time
Configure the settings for initial start-up. Clean the ap-
pliance and accessories.
Setting an operating mode
Your appliance is set to air extraction mode by default.
To use it in circulating-air mode, you must set the oper-
ating mode.
Note:
For use in circulating-air mode, you require addi-
tional Accessories.
Requirement:
The appliance is switched off.
1.
Press and hold and for approx. three seconds.
‒
To set circulating-air mode (non-regenerable fil-
ter), press / until LED 2 lights up in the LED
display.
‒
To set circulating-air mode (non-regenerable fil-
ter), press / until LED 3 lights up in the LED
display.
‒
To convert the electronic control back to opera-
tion without the air recirculation filter, press /
until LED 1 lights up on the LED display.
2.
To save the setting, press and hold and for ap-
prox. three seconds.
Or wait approx. 10 seconds until the setting is
saved automatically.
To cancel the setting, press .
a
A signal tone sounds as soon as the selected set-
ting is saved.
Basic operation
You can find out everything you need to know about
operating your appliance here.
Switching on the appliance
Requirement:
Align the remote control as precisely as
possible to the infrared receiver for the LED display.
▶
Press to switch on the appliance.
a
The appliance starts at fan setting 2.
a
The LED for the set fan setting lights up in the LED
display.
Switching off the appliance
Switch the appliance off when you are not using it.
▶
Press to switch the appliance off.
a
The appliance switches off. Any functions currently
in progress are cancelled.
Summary of Contents for I95CBS8W0 Series
Page 23: ......
