NEFF GI7.13 Series, User Manual

Page: 48 / 132

en
Troubleshooting
48
Information on display panel
Fault Cause troubleshooting
Message showing "D" or "E"
appears in the display. The electronics have detec-
ted a fault.
▶
Call the after-sales service.
→
"Customer Service", Page 51
Temperature display flashes. Different causes are pos-
sible.
▶
Press .
a The alarm is switched off.
The appliance door is open.
▶
Close the appliance door.
The ventilation openings are
covered up.
▶
Remove any obstructions from in
front of the ventilation openings.
Larger quantities of fresh
food have been put in.
▶
Do not exceed the max. freezing ca-
pacity.
→
"Freezing capacity", Page 42
The temperature display
flashes, a warning signal
sounds and
lights up.
Different causes are pos-
sible.
▶
Press .
a The alarm is switched off.
The appliance door is open.
▶
Close the appliance door.
The ventilation openings are
covered up.
▶
Remove any obstructions from in
front of the ventilation openings.
Larger quantities of fresh
food have been put in.
▶
Do not exceed the max. freezing ca-
pacity.
→
"Freezing capacity", Page 42
Temperature problem
Fault Cause troubleshooting
The temperature differs
greatly from the setting. Different causes are pos-
sible.
1.
Switch off the appliance.
→
Page 40
2.
Switch the appliance back on after
five minutes.
→
Page 40
‒
If the temperature is too
warm, check the temperature
again after a couple of hours.
‒
If the temperature is too cold,
check the temperature again
on the following day.
Noise
Fault Cause troubleshooting
Appliance has a humming
sound. Not a fault. A motor is run-
ning, e.g. refrigerating unit,
fan. No action required.