NEFF DIKP951S, Instructions For Installation And Use Manual

Page: 13 / 28

Operating the appliance
en
13
AmbientLight
The AmbientLight can be switched on and off
independently of the fan.
Touch the
k
symbol.
Setting the brightness
Press and hold the
k
symbol until the required
brightness is reached.
Setting the colour
1.
Switch off the fan.
2.
Touch the
k
symbol.
The
@
and
A
symbols will be lit for approximately
10 seconds.
3.
Within this 10-second period, touch the
A
or
@
symbol until the colour you require is selected.
Lighting
The lighting can be switched on and off independently
of the fan.
Touch the
6
symbol.
Setting the brightness
Press and hold the
6
symbol until the required
brightness is reached.
Saturation display
If the metal grease filters or activated charcoal filter are/
is saturated, the corresponding symbols will flash once
the appliance has been switched off:
■
Metal grease filter: ”ªª
■
Activated charcoal filter: ’ªª
■
Metal grease filter and activated charcoal filter:
”ªª
and
’ªª
If you have not yet done so, the metal grease filters
should now be cleaned or the activated charcoal filter
replaced.
~
"Cleaning and maintenance" on page 16
The saturation indicators can be reset while they are
flashing. To do this, touch the
A
symbol.
Switching over the display for air recirculation mode
For air recirculation mode, the electronic controller must
be switched over accordingly:
■
The extractor hood must be connected and switched
on.
■
Touch and hold the
Q
symbol and touch the
@
or
A
symbol until "2" lights up for air recirculation mode
(filters that cannot be regenerated). Take your finger
off the
Q
symbol. This will switch the electronic
controller over to air recirculation mode (filters that
cannot be regenerated).
■
Touch and hold the
Q
symbol and touch the
@
or
A
symbol until "3" lights up for air recirculation mode
(filters that can be regenerated). Take your finger off
the
Q
symbol. This will switch the electronic controller
over to air recirculation mode (filters that can be
regenerated).
■
Repeatedly touching and holding the
Q
symbol and
touching the
@
or
A
symbol until "1" lights up
switches the electronic controller back over to air
extraction mode.
Audible signal
Switching on
Touch and hold the
#
and
Q
symbols at the same time
for approximately 3 seconds when the fan is switched
on. An audible signal will sound as an
acknowledgement.
When the signal tone is activated,
‚
will be lit.
Switching off
Touch and hold the
#
and
Q
symbols at the same time
for approximately 3 seconds when the fan is switched
on. An audible signal will sound as an
acknowledgement.
When the signal tone is deactivated,
‹
will be lit.