Basic operation
en
7
Ba s ic ope ra tion
7 Basic operation
7.1 Switching on the appliance
▶
Press .
a
The appliance starts at fan setting 2.
7.2 Switching off the appliance
▶
Press .
7.3 Setting a fan setting
▶
Press or .
7.4 Switching on intensive mode
If particularly strong odours or vapours develop, you
can use intensive mode.
1.
To switch on intensive mode 2, press .
a
appears on the display.
2.
To switch on intensive mode 1, press again.
a
appears on the display.
a
After approx. 6 minutes, the appliance automatically
switches to fan setting 3.
7.5 Switching off intensive mode
▶
Press .
7.6 Switching on the fan run-on
1
During the fan run-on, the appliance continues to run
for a short time and then switches off automatically.
▶
Press .
a
The fan run-on starts at fan setting 1.
a
The appliance switches off automatically after ap-
prox. 10 minutes.
7.7 Switching off the fan run-on
1
▶
Press .
7.8 Switching on the AirFresh function
The AirFresh function switches on the ventilation sys-
tem for approx. five minutes per hour at fan setting 1.
▶
Press
.
a
appears on the display.
7.9 Switching on the NoiseReduction
function
1
The noise reduction function reduces the fan noise.
The function is possible in all fan settings, except in fan
setting .
▶
Press .
a
The NoiseReduction function remains active even
after the appliance is switched off.
7.10 Switching on automatic mode
The optimum fan setting is set automatically using a
sensor.
▶
Press .
7.11 Switching off automatic mode
▶
Press .
a
The ventilation is automatically ended when the
sensor detects no further change in the room air
quality.
a
Automatic mode runs for a maximum of four hours.
7.12 Sensor sensitivity
In automatic mode, a sensor in the appliance detects
the intensity of the cooking and roasting fumes. De-
pending on the setting of the sensor sensitivity, the op-
timum fan setting is automatically switched on. If the
sensor control system reacts too weakly or too
strongly, the setting for the sensor sensitivity may
change.
¡
Factory setting: 5
¡
Lowest setting: 0
¡
Highest setting: 9
7.13 Setting the sensor sensitivity
Requirement:
The appliance is switched on.
1.
Press and hold .
a
The setting is displayed after approx. one second.
2.
Press or to change the setting.
3.
Release to save the setting.
7.14 Switching on the lighting
The lighting can be switched on and off independently
of the ventilation system.
Note:
Colour temperature settings are available in the
Home Connect app provided the appliance has this
function.
▶
Press .
7.15 Setting the brightness
▶
Press and hold until the required brightness is
reached.
7.16 Switching on Ambient Light
1
You can switch on the Ambient Light independently of
the ventilation system.
▶
Press .
7.17 Ambient Light - Setting the brightness
1
▶
Press and hold until the required brightness is
reached.
1
Depending on the appliance specifications
