NEFF D64MAC1X0 Series, Instruction Manual

Page: 8 / 12

en
Trouble shooting
8
By hand:
Note:
You can use a special grease solvent for
stubborn dirt. It can be ordered via the Online Shop.
■
Soak the metal mesh grease filters in a hot soapy
solution.
■
Clean the filters with a brush and then rinse them
thoroughly.
■
Leave the metal mesh grease filters to drain.
In the dishwasher:
Note:
If the metal mesh grease filters are cleaned in the
dishwasher, slight discolouration may occur. This has
no effect on the function of the metal mesh grease
filters.
■
Do not clean heavily soiled metal mesh grease filters
together with utensils.
■
Place the metal mesh grease filters loosely in the
dishwasher. The metal mesh grease filters must not
be wedged in.
Installing the metal mesh grease filter
1.
Insert metal grease filter.
2.
Fold up metal grease filter and engage the lock.
Note:
Make sure that the filter lock engages properly.
Changing the activated charcoal filter (only in
circulating-air mode)
In order to guarantee efficient odour filtration, the filter
must be serviced regularly.
The activated charcoal filters must be replaced at least
every 4 months.
Notes
■
The activated charcoal filters are not included in the
delivery. The activated charcoal filters can be
obtained from specialist retailers, from our after-
sales service or from the Online Shop.
■
The activated charcoal filters cannot be cleaned or
reactivated.
1.
Remove the metal grease filters; see above.
2.
Turn the old activated charcoal filters and pull them
out of the retainer.
¨
3.
Push the new activated charcoal filters into the
retainer and turn.
©
4.
Fit the metal grease filters; see above.
3
Trouble shooting
Trouble shooting
Malfunctions often have simple explanations. Please
read the following notes before calling the after-sales
service.
:
Warning – Risk of electric shock!
Incorrect repairs are dangerous. Repairs may only be
carried out and damaged power cables replaced by
one of our trained after-sales technicians. If the
appliance is defective, unplug the appliance from the
mains or switch off the circuit breaker in the fuse box.
Contact the after-sales service.
Fault table
--------
Problem Possible cause Solution
The appliance
does not work
The plug is not
plugged into the
mains
Connect the appliance to the
power supply
Power cut Check whether other kitchen
appliances are working
The fuse is faulty Check in the fuse box to make
sure that the fuse for the appli-
ance is in working order
The lighting does
not work.
The LED lights
are defective.
You can read about this in the
section entitled "Replacing the
LED lights".