en
Appliance door
32
Fitting the bar
1.
Fit the bar at the back .
2.
Slide the bar towards the back and hook it down-
wards onto the pin .
3.
Ensure that the hook is hooked onto the pin .
Detaching the rails
WARNING ‒ Risk of burns!
The shelf supports get very hot
▶
Never touch the shelf supports when hot.
▶
Always allow the appliance to cool down.
▶
Keep children at a safe distance.
1.
Lift the rail forwards slightly and detach it .
2.
Pull the whole rail to the front and remove it.
3.
Clean the rail.
→
Attaching the rails
Note:
The rails only fit on the right or left and must be
pulled out towards the front.
1.
First, push the rail into the middle of the rear
socket until the rail rests against the cooking
compartment wall, and then push this back .
2.
Push the rail into the front socket until the rail
also rests against the cooking compartment wall,
and then press this downwards .
21 Appliance door
To clean the appliance door thoroughly, you can disas-
semble the appliance door.
WARNING ‒ Risk of injury!
If the hinges are not secured due to an incomplete
lock, they can snap shut with great force.
▶
To detach or attach the appliance door, always turn
the two locks as far as they will go.
▶
If the hinge snaps closed when detaching or attach-
ing the appliance door, do not reach into the hinge
– call the after-sales service.
21.1 Detaching the appliance door
Requirements
¡
Have a torch ready.
¡
Have a small slotted screwdriver ready.
¡
Have a coin ready.
1.
To make it easier to see the door lock, shine the
torch into the gap beside the appliance door.
