10
CLEARSKY DPF (PG 1050 & PG1060) INSTALLATION MANUAL
Figure 21. Wire ties.
Figure 22. Wire ties.
Installing the DPF Controller Harness
• Tie wrap the harness to the Teck cable with 11” of harness measured from
the Teck cable P-clamp to the 12 pin connector (refer to figure 20).
• Route the harness beside the Teck cable for 4” then route along the 12v
APU power cables until you reach the red and black DPF Controller power
wires. Tie up as shown in figure 21, 22 and 23.
Step 9
Figure 23. Wire ties.
Figure 20. DPF harness length.
