Doc. no#: 310-0050-001-002 R103 Manual
Page 10
Fault finding
When errors occur the LED will indicate this. The following will give you a guide to find these errors.
In the Neets Control – ZULU the LED´s are placed here:
Fault
Solution
SD card missing
Control that the SD card is mounted correctly and that the
uSD card that you are using are formatted with FAT.
Unexpected Error
There are properly problems in the project you have
uploaded. Try e.g. to upload a empty project and see if this
works or contact Neets or you dealer
Error in serial number
Doing the production of the unit, something has gone
wrong. You need the return the unit to Neets or your
dealer for replacement/repair.
Unzipping config.zip
file after power on
If you manual have placed a project file on the uSD card
the system will extract the files needed to run the project.
After extraction, the system will start to run the project.
Unable to start the
project
This scenario often happens when the uSD card in the unit
are replaced with a blank uSD card. Alternative there can
be a problem in the project you have uploaded. Try e.g. to
upload a empty project and see if this works or contact
Neets or you dealer
System are in boot
mode
You have put the system in boot mode. This mode allows
you to communicate with the system using Rx1/Tx1. See
the section “Switch and LED” on page 7 for details on how
to get the system into boot mode.
Summary of Contents for Zulu
Page 1: ......
