VP1007-B / Installation manual
Version 01.000 / November 2020 / EN
26
Livestock Management
LED
Color
Mode
State
Red
Blinking
Output error / overload
Green
On
Input contact open
I1 .. I5
Blank
Off
Input contact closed
On
Antenna 1 tuned correctly
Blinking
Antenna 1 identified tag
On
Antenna 2 tuned correctly
Blinking
Antenna 2 identified tag
Red on
Antenna 1 not tuned correctly (turn left)
Red on
Antenna 1 not tuned correctly (turn right)
Red on
Antenna 2 not tuned correctly (turn right)
Red on
Antenna 2 not tuned correctly (turn left)
Red blinking
Antenna 1 not connected or low antenna signal
TUNING/ID
Various
Red blinking
Antenna 2 not connected or low antenna signal
11.2 VP1007-B reader menu overview
Use the button to access the menu and to display or change the settings:
1. Push the button briefly to go through the menu options.
2. Push and hold down to go to the second or third level of the menu.
3. Push and hold down until the display blinks to change a menu item.
•
If the button is not pushed again, the display goes blank automatically.
•
To leave the menu at any point, push and hold down the button until the display goes blank.
First
level
Second
level
Third
level
Settings
Description
Show IP
address
The first time the button is pushed briefly, the current IP
address is shown in the display
Address settings
Display address
