UPASS ACCESS | INSTALLATION GUIDE
Reader Configuration
13/23
Example 2
Read only NXP UCODE tags (TID starts with E2006) and read 4 words from user
memory.
Figure 7: Read data example 2
5.2.2
DECODE NEDAP XS
Enable decode Nedap XS formatted tags. Introduced in firmware version 2.54.
Figure 8: Output settings
By default the data on NEDAP XS formatted tags will be transmitted to the TRANSIT
compatible processor or the the NEDAP antenna modulation interface. In this case
the UPASS will not perform any decoding.
Enable decode Nedap XS when you do not want to use the TRANSIT compatible
processor or the antenna modulation interface. The UPASS will decode the NEDAP
XS tag data and output its plain tag-number. You can also enable to output or verify
the customer code.
Enable the option 'Allow other tag formats' when you want the reader to support
also other formatted tags, such as NEDAP UHF Wiegand formatted tags and others.
The decoded NEDAP XS output number contains:
Byte 1:
4E
NEDAP UHF
Byte 2:
<FMT> FMT=01: Nedap XS decoded hex tagno
FMT=02: Nedap XS decoded decimal tagno.
Byte 3-4:
00
Unused
Byte 5-7:
CC
CC=Customer code (zero if not transmitted)
