+
-
Strain relief & cover
Make sure all cables are properly secured
and the protection cover is placed back
over the terminals.
Power ON
Make sure to close the enclosure before
connecting the AC mains.
If powered devices are not working properly
please check if the DC output is 13.2 V.
The DC output can be adjusted with the
Voltage adjuster.
AC mains input
-V +V
Live
(brown)
AC mains
Neutral
(blue)
L
N
3 x 0.75 mm², earth connection, max. 2 m
Make sure that the AC mains (230-240 VAC)
is NOT connected!
Shield & earth
-V +V
Shield
AC mains
DC output
Earth wire
(green-yellow)
The protective earth wire should be the
last to disconnect in the event of an
inadvertent pull on the power cord.
DC output
1
2
3
-V
+V
GND
Vin
DC output
2 x 0.5 mm
2
shielded, max. 5 m
Remove the protection cover from the
terminals before wiring.
A
B
DC output
AC mains input
Power LED
Voltage adjuster
L
N
-V +V
Protection cover
1
3
2
5
4
5
Wiring speci
fi
cations
Purpose
A.
AC mains input wiring
B.
DC output wiring
Specification
3 x 0.75 mm², earth connection, max. 2 m
2 x 0.5 mm
2
shielded, max. 5 m
Failure to comply with the wiring specifications may result in
malfunction and/or dangerous situations.
Instructions
Step
1.
2.
3.
4.
5.
DC output
Shield & earth
AC mains input
Strain relief & cover
Power ON
Remarks
Default output is 13.2 V.
Connect shield and earth wire at the same time to the same terminal.
Make sure the AC mains input is still disconnected at this point.
Use the available provisions to secure all cables.
Make sure the protection cover is put back over the terminals.
Before installing or servicing this device
please read and take the ‘Safety precautions’
into account. These can be found on the
backside of this installation guide.
Conductors connected to the screw
terminals must be fitted with a ring,
crimped lugs, etc. so that reliance is not
placed upon the screw alone.
