NED XCM8060SA, User Manual

Page: 27 / 82

NED
UME-0034-03 XCM8060SA_8040SA_6040SA
27
4.1.4 Camera Control Commands
The table below shows the
list of Camera Control Commands
.
Table 4-1-4-1 List of Camera Control Commands
Control Item CMD VAL1 VAL2 VAL3 Control Description
Analog Gain gax
0 to
20
x1.00...x11.22(1.06dB/step)
Digital Gain gdx
0 to
511
x1...x2(x0.003906/step)
Digital Offset odx
-15 to
15
-15...15(1DN/step
at8bit)-60...60(4DN/step at10bit)
Exposure Mode inm 0 /1/2 Free Run / Ext Edge / Ext Level
Programmable Exposure
Time
int 0 to 11
61 to
1023
32.5
～
117388.8
μs
（
XCM8060SA
）
48.8
～
1676083.2
μs
（
XCM8040SA
）
36.6
～
1257062.4
μs
（
XCM6040SA
）
(VAL1: Dividing, VAL2: Counter)
Output Signal Setting 1 voa 0 /1 0 to 9 8bit /10bit
、
Output block selection
Output Signal Setting 2 voc 0 /1 Linear /log
Setting Multi-Slope level msl 0 to 15 0 to 15 0 to 15
Set the output level aspect of the vertex of
the multi-slope function
VAL1<=VAL2<=VAL3
Setting Multi-Slope timing mst
0 to
511
0 to
511
0 to
511
Set the timing aspect of the vertex of the
multi-slope functionVAL1<=VAL2<=VAL3
i.e. when using 4 slopes, select values
such that VAL2/VAL1 and VAL3/VAL2
work out to the same result. Moreover, the
result should be less than 10.
Memory Initializing rst Reset to factory settings
Memory Load rfd Readout setup data in memory
Memory Save sav Store present setup data in memory
Test Pattern tpn 0 /1 OFF/ON
Pixel Correction Data Save wht Store pixel correction data in memory
Pixel Correction Setting shc 0/1/2
0 to
1023
0:Correction OFF /1:Factory white
correction /2:User white correction,
Correction level (10-bit)