Configure Outgoing Calls
30
XN120 Voice Over IP Card Guide
14- Configure Caller ID
Receiving Caller ID
The VOIPU lines will receiver Caller ID at default, the Caller ID will be displayed at the LCD display of the
XN120 telephones or normal telephones with caller ID enabled (Caller ID is enabled by Program 15-03-09 for
each normal telephone).
For the correct display of the CLIP you must enable the automatic insertion of the prefix digits (0 for national
calls and 00 for international calls).
This is enabled by Program 20-19-03, set this option to 1 to enable the insertion of the 0 or 00 prefix digits.
If the Caller ID received on an incoming call matches an entry in the system Telephone Book then the name
assigned in the Telephone Book will also be displayed.
Sending Caller ID
The system can send caller ID for outgoing calls.
The Caller ID can be specified per VOIPU line (PRG21-17), per telephone (PRG21-19) and per system
(PRG10-28-04).
The flowchart below shows which Caller ID setting will be used for a SIP call.
