NEC WL1700-MS, Installation Manual

Page: 120 / 226

Data Assignment
Chapter 4
INITIAL SETUP
86
Note.
Under no circumstances should you specify a country code that does not match
the country of operation. If the country of operation is not listed in this table, this might
be because the country has not yet approved the use of this equipment. In this case,
contact your local supplier before installing the equipment.
The following is an example when Country Code ( United State ) is specified in the
command.
7
Assign an IP address on each interface.
Type set interface {VLAN ID:1–4093} ip {IP Address} {Subnetmask} to
assign IP addresses to Interfaces on the Controller.
The following is an example when vlan ID ( 1 ), IP address ( 192.168.10.10 ),
and Subnet mask ( 255.255.255.0 ) are specified in the command.
8
Assign a system IP address to the Controller.
India IN Switzerland CH
Ireland IE Taiwan TW
Israel IL Thailand TH
Italy IT United Arab
Emirates
AE
Japan JP United Kingdom GB
Liechtenstein LI United States US
Luxembourg LU – –
Country Country Code Country Code Country Code
WL111111 # set system countrycode us
Basic Settings
WL111111# set interface 1 ip 192.168.10.10 255.255.255.0
Basic Settings