NEC Versa P700 Disassembly Manual
Page 9
Fig. 9:
Disconnecting the keyboard cable
5. Gently pull the connector latch as shown above, to release the keyboard cable.
6. Take the keyboard off the notebook and put it aside.
Removing the LED Assy
To remove the LED assy, first remove the keyboard cover (see
) and
then perform the following steps:
1. Extract the antenna cable that passes to the hole in the LED assy and goes to the
Wireless Mini PCI Card.
Note:
You will need to disconnect the antenna cable from the Wireless Mini PCI Card if you have not
done so previously. Refer to the section
Removing the Wireless Mini PCI Card
for instructions.
2. Disconnect the flat cable from the LED assy, by unlocking the retaining latch and
carefully removing the cable as shown here.
Fig. 10:
Disconnecting the flat cable from the LED assy
3. Now disconnect the flat cable from the main board as shown below and put it aside:
