NEC Univerge UM8000, User Manual

Page: 304 / 469

UNIVERGE
®
UM8000 Message Networking 304
Adding a New Remote Site
The remote system must be defined on the local UNIVERGE
®
UM8000 system to enable communications between the
systems. The location definition includes all of the information required for UNIVERGE UM8000 to establish
communication and exchange messages with the remote system. This is the phone number required to reach the
remote system in
AMIS or PlusNet.
Create the local definition by adding the remote site.
To add a new remote site
1.
In the Navigation Pane, click Network > Remote Sites .
2.
Click Add . See “ Administration Console Pages ,” for information about the Administration Console icons.
The Add site dialog box appears.
a.
Select the protocol in the Protocol section: AMIS or PLUSNET - 1
b.
Select one of the following in the Network site type:
• Open. If the systems are exchanging messages using a public phone network. Type the country code,
area code, and phone number.
• Other carrier (Private). If the systems are exchanging messages over a private phone network. Type a
Private ID for the site.
c.
Type a system ID for the remote site in the System ID field.
d.
Type a name for the remote site name in the Remote site name field. Use a descriptive name.
e.
Click Add to add another remote site, or click Done to close the Add Site dialog box.
3.
Configure the general parameters for the remote site.
See “ Configuring General Parameters for a Remote Site .”
Related Topics
Configuring General Parameters for a Remote Site
About Networking Protocols
UNIVERGE
®
UM8000 Message Networking
Understanding Directories