NEC UNIVERGE SL2100, Programming Manual

Page: 660 / 678

Program 92 : Copy Program
92-01 : Copy Program
Level:
IN
Description
This program is available only via telephone programming and not through PC Programming.
Use Program 92-01 : Copy Program to copy the data for one program to another multiline terminal,
port, group, or other number. Refer to the following charts to see which programs can be copied.
Input Data
Program Number XX ~ XX
Item No. Item Input Data Description
01
Source Number • For Trunk Base : Trunk Port Number
1 ~ 128
• For Trunk Group Base : Trunk Group
Number 1 ~ 50
• For Extension Base : Extension Num-
ber Maximum eight digits
• For Department Group Base : De-
partment Group Number 1 ~ 50
• For DSS : DSS Console Number 1 ~
12
• For Door Phone: Door phone num-
ber : 1 ~ 6
Enter the extension, trunk, group
or other number from which the
data is to be copied.
Destination Number (From) Enter the first extension, trunk,
group or other number to which
the information is to be copied.
Destination Number (To) Enter the last extension, trunk,
group or other number to which
the information is to be copied. If
the information is being copied
only to one extension, trunk,
group or other number, enter the
information entered in the Desti-
nation Number (From) entry.
The Copy Program is applicable only for the following programs :
Trunk Port Base
Program No. Program Name
14-01 Trunk Basic Data Setup
Copy all data except Trunk Name (Item 01).
14-02 Analog Trunk Data Setup
14-04 Behind PBX Setup
14-08 Music on Hold Source for Trunks
14-09 Conversation Recording Destination for Trunk
20-30 Timer Class for Trunk
21-03 Trunk Group Routing for Trunks
21-12 ISDN Calling Party Number Setup for Trunk
21-21 Toll Restriction for Trunks
21-22 CO Message Waiting Indication
SL2100 ISSUE 2.0
2-636 Program 92 : Copy Program
Program
92