NEC UNIVERGE SL2100, Programming Manual

Page: 18 / 678

When you want to ... Telephone Programming
Apply Hold
Enter
Go Back to Prior Screen Mute
Clear / Back
Move Cursor Jump Up/Down DND
Delete single character Clear / Back
Next Page Help
Toggle between Number/Character
While in a Entering Number
Prior Page Transfer
Quit the programming Speaker
Exit
Move Cursor to Left Cursor Key (Left)
Soft Key1
Change Program Number Soft Key2
Change Index Number
Change Program Number Soft Key3
Change Index Number
Move Cursor to Right Cursor Key (Right)
Soft Key4
Section 6 PROGRAMMING NAMES AND TEXT MESSAGES
Several programs (e.g., Program 20-16 : Selectable Display Messages) require you to enter text. Use
the following chart when entering and editing text. When using the keypad digits, press the key once
for the first character, twice for the second character, etc. For example, to enter a C, press the key
2
three times. Press the key six times to display the lower case letter. The name can be up to 12 digits
long.
Table 1-2 Keys for Entering Names
Use this keypad digit ... When you want to ...
1 Enter characters : 1 @ [ ¥ ] ^ _ ` { | } Á À Â Ã Å Æ Ç É Ê ì ó 0
2 Enter characters : A-C, a-c, 2 .
3 Enter characters : D-F, d-f, 3 .
4 Enter characters : G-I, g-i, 4 .
5 Enter characters : J-L, j-l, 5 .
6 Enter characters : M-O, m-o, 6 .
7 Enter characters : P-S, p-s, 7 .
8 Enter characters : T-V, t-v, 8 .
9 Enter characters : W-Z, w-z, 9 .
0 Enter characters : 0 ! “ # $ % & ’ ( ) ô õ ú å ä æ ö ü α ε θ В
*
Enter characters :
*
+ , - . / : ; < = > ? π Σ σ Ω ∞ ¢ £
# # = Accepts an entry (only required if two letters on the same key are needed - ex : TOM).
Pressing # again = Space. (In system programming mode, use the right arrow Softkey in-
stead to accept and/or add a space.)
Clear/Back or DND (2W Digital/IP
Multiline Terminal)
Clear the character entry one character at a time.
SL2100 ISSUE 2.0
1-4 Introduction