NEC UNIVERGE SL2100, Programming Manual

Page: 142 / 678

Program 14 : Trunk, Basic Setup
14-02 : Analog Trunk Data Setup
Level:
IN
Description
Use Program 14-02 : Analog Trunk Data Setup to set the basic options for each analog trunk port.
Refer to the table below for a description of each option, its range and default setting.
Input Data
Trunk Port Number 1 ~ 128
Item
No.
Item Input Data Description Default Related
Program
01 Signaling Type
(DP/DTMF) 0 = Dial Pulse (10 PPS)
2 = DTMF This option sets the signaling type
for the trunk. 2
02 Ring Detect Type 0 = Normal/delayed
1 = Immediate Ringing This option sets Extended Ring De-
tect or Immediate Ring Detect for
the trunk. For T1 loop/ground start
trunks, this option must be set to 1
for the trunks to ring and light cor-
rectly. 1
03 Flash Type 0 = Open Loop Flash
1 = Ground This option selects the flash type
(open loop flash or ground). Always
set this option for open loop flash. 0
04 Hooking Type 0 = Timed Flash (Hook-
ing)
1 = Disconnect (Cut) This option lets you use Flash for
Timed Flash (Program 81-01-14) or
Disconnect (Program 81-01-15). (A
user implements Flash by pressing
the FLASH key while on a trunk
call.) 0 81-01-14
81-01-15
05 Dial Tone Detec-
tion for Manually
Accessed Trunks 0 = Dial Tone Detection
Not Used
1 = Dial Tone Detection
Used Use this option enable/disable dial
tone detection for directly accessed
trunks. If disabled, the system out-
dials on the trunks without monitor-
ing for dial tone. 0 21-01-04
06 Pause after First
Digit For Manual-
ly Dialed Calls 0 = No Pause (No)
1 = Pause (Yes) 1 21-01-06
SL2100 ISSUE 2.0
2-118 Program 14 : Trunk, Basic Setup
Program
14