NEC UNIVERGE SL2100, Hardware Manual

Page: 144 / 174

S
ECTION
2 PROGRAMMING MODE
2.1 Entering the Programming Mode
The installer/system administrator can enter to the system programming mode from the Display Type
Multiline Telephone. (A maximum of two users can enter mode at the same time)
In a newly installed system, use extension port 1.
1. Press Speaker key. (Do not lift the handset)
2. Dial #
*
#
*
.
Password
TUE18 7:27PM
200
Figure 3-5 Entering Programming Mode Display 1 (12TXH/24TXH-A1)
11-10 WED 1:49PM
200
Menu Dir VM:00 CL:00
Password
Figure 3-6 Entering Programming Mode Display 1 (12TXH/24TXH-B1)
3. Dial the system password, then press Hold key to enter the Program Mode.
Password@@@@@@@@
Program Mode
Figure 3-7 Entering Programming Mode Display 2 (12TXH/24TXH-A1)
Password@@@@@@@@
Program Mode
Base Service OP1 OP2
Figure 3-8 Entering Programming Mode Display 2 (12TXH/24TXH-B1)
For the details of programming, refer to the SL2100 Programming Manual. (separate issue)
SL2100 ISSUE 1.0
3-4 System Start Up