NEC SV8500, Manual

Page: 2985 / 3438

VOL.3-498
CHAPTER 4 CONFIGURATION SETUP
2.4 Enable/Disable AutoConfig Mode from DtermIP Menu
The following shows how to enable/disable AutoConfig Mode from the DtermIP Configuration Menu.
STEP 1: Open the User Menu by pressing “Hold” + “Transfer” + “*” + “#” on the terminal while indicating
time, an error message, or “DHCP Connecting.../DRS (1st) Connecting...”.
STEP 2: Open the Administrator Menu (Page 1) by pressing “Hold”+“#”+“0” on the User Menu. Select “0.
Next Page (P1 >> P2)” by pressing “0” on the Administrator Menu (Page 1).
STEP 3: The Administrator Menu (Page 2) is displayed. For Dterm Series i , select “4. AutoConfig Mode” by
pressing “4”. For Dterm Series E/Dterm 75, select “3. Auto Config Mode” by pressing “3”.
STEP 4: The display changes as follows. When disabling the AutoConfig Mode, choose “1. Disable” by press-
ing “1”. When enabling the AutoConfig Mode, choose “2. Enable” by pressing “2”. Then press OK
key.
Save
1.DHCP Mode
2.DRS Address Primary
Up Down Cancel
[User Menu]
Exit
9.Language
0.Next Page (P1>>P2)
Up Down
[Administrator Menu (Page1)]
3.Ring Volume Loudness
4.AutoConfig Mode
Up Down
[Administrator Menu (Page2)]
2.Music Select
3.AutoConfig Mode
Up Down
[Administrator Menu (Page2)]
(Dterm Series i )
(Dterm Series E/Dterm 75)
OK
1.Disable
2.Enable
Cancel