NEC SV8500, Manual

Page: 2314 / 3438

VOL.2-2061
VS-32(Dual) [SCA-VS32VA/MG-VS32VA]
F
SIP mode
This command assigns RTP start port (UDP). RTP start port is used for voice data communication between
the counter party’s devices; which reserves the port number 1024 from the specified port. Usually use the
default value for RTP start port.
Note:
To make this assignment effective, use the SAVE command, and restart before exiting the maintenance com-
mand.
Note:
The value in ( ) shows the current setting.
11. Setting signaling port number for SIP:
This command assigns the port number for SIP signaling session (for SIP mode only).
Note:
To make this assignment effective, use the SAVE command, and restart before exiting the maintenance com-
mand.
12. Setting QoS for SIP signaling session:
This command assigns quality of service data for SIP signaling session (for SIP mode only).
VS-32(SIP)> SET PORTNUMBER
RTP Start port number(1024): 1024
Enter RTP start port (default=1024)
Port Number setting succeeded.
Result is shown.
VS-32(SIP)> SET SIGNALING_PORT_NO P1
P1 : Enter the port number used for SP-PHI.
[1024-65535] (default=5060)
Signaling port number setting succeeded.
Result is shown.
VS-32(SIP)> SET SIGNALING_QOS P1 P2 P1 : Enter either of the following parameters or press
Enter key to skip P1 and P2 to move on to TOS/
DIFFSERV setting in dialog format.
TOS=to set IP Precedence data value
DIFFSERV=to set Diffserv data value
CLEAR=to clear QoS setting
P2 : Enter the setting value,
When TOS is selected in P1: 0x02~0xFF
When DIFFSERV is selected in P1, enter DSCP
value: 0~63