NEC SV8500, Manual

Page: 2312 / 3438

VOL.2-2059
VS-32(Dual) [SCA-VS32VA/MG-VS32VA]
6. Setting the communication speed of LAN interface:
Be sure to assign this data adjusting to the network devices (router, switch, or HUB, etc.). This data can be
set also in
SETUP TP and SETUP SP command.
Note:
DUPLEX setting does not appear when AUTO (Auto Negotiation) is selected in SPEED setting.
Note:
To make this assignment effective, use the SAVE command, and restart before exiting the maintenance com-
mand.
7. Setting IP address and subnet mask of VS-32(Dual):
Be sure to assign this data when static addressing is used in the network. This data can be set also in SETUP
TP and SETUP SP command.
Note:
To make this assignment effective, use the SAVE command, and restart before exiting the maintenance com-
mand.
Note:
The designated IP address cannot be applied when DHCP is set to ENABLE. Be sure to assign the DHCP
setting to DISABLE before performing this IP address assignment.
VS-32> SET INTERFACE P1 P1 : Enter interface name (*can be skipped).
SPEED (AUTO/100M/10M): 100M Select the communication speed
AUTO=Auto Negotiation (default)
100M=100 Mbps fixed mode
10M=10 Mbps fixed mode
DUPLEX (FULL/HALF): FULL Select the Duplex mode
FULL=Full Duplex mode
HALF=Half Duplex mode
Ethernet Speed setting succeeded. Result is shown.
VS-32> SET IPADDRESS P1 P2
P1 : Enter the IP Address of VS-32(Dual)
(e.g. IP address: 10.41.1.100)
P2 : Enter the Subnet Mask
(e.g. Subnet mask: 255.255.255.0)
IP Address set complete.
Result is shown.