NEC SV8500, Manual

Page: 2292 / 3438

VOL.2-2039
VS-32(Dual) [SCA-VS32VA/MG-VS32VA]
SETUP
Basic settings for IP related data such as IP addresses, subnet mask, and DHCP used in VS-32(Dual) is assigned
by this command. This command must be executed when starting up VS-32(Dual) on the initial setting.
Assign IP network data and music source file following the setting command shown in dialog form. Be sure to
save the entered data at the end of each SETUP command.
Note:
When any abnormal data is entered, the dialog asks to enter proper data until three times. The third time
you enter illegal data, the SETUP command quits discarding all the entered data.
Note:
When you quit the SETUP command entry halfway through the setting, all the entered data is to be discard-
ed.
1. Setting basic IP data for SIP mode:
F
To startup SETUP SP command:
F
Setting one time password (*this setting is displayed when one time password has not been assigned yet) :
VS-32>
VS-32> SETUP SP Enter “SETUP SP” following the prompt.
No One Time Password!!
Please input a one time password
One Time Password:
123456
Enter one time password (e.g. 123456).
Erase start...
Erase OK!
Write start...
Write OK! Writing to Flash ROM is executed.
One time password setting succeeded.
Result is shown.