NEC SV8500, Manual

Page: 2270 / 3438

VOL.2-2017
VS-32(Dual) [SCA-VS32VA/MG-VS32VA]
24.3.4 Configuration Command Assignment
Assign the network configuration data by command operation on maintenance console.
This section consists of two parts; procedure for Proprietary Protocol mode and procedure for SIP mode. The
following explains the procedure by each mode, after finishing the procedure of startup maintenance command.
Note:
“DRS (Device Registration Server)” used in this section refers to the Telephony Server. When VS-32(Dual)
works in Proprietary Protocol mode, the Telephony Server acts as DRS, which is controlling function of the
Telephony Server.
Note:
“SIP server” used in this section refers to the Telephony Server. When VS-32(Dual) works in SIP mode, the
Telephony Server acts as SIP server.
Note:
The setting data here is an example. Assign the network data adjusting to your network configuration.
[Startup maintenance command]
STEP 1: When the boot program is started, the initial display below is displayed on the screen.
STEP 2: Maintenance command launches by entering usrConsole. Type “usrConsole” following the OS
prompt (->) and press ENTER key.
STEP 3: When the system is ready, VS-32(Dual)’s default command prompt “
VS-32>
” appears.
VS32-ID: xxxxxxxx
Starting boot program...
--- Online program Initial start (Wait for a while) ---
:
:
:
->
->
->
->
usrConsole
VS32 Maintenance command Version 3.00 2006.6.19
VS-32>_