NEC SV8500, Manual

Page: 1977 / 3438

VOL.2-1724
MG-SIP16
20.4.5 Cable Connection
STEP 1: Connect MG-SIP16 to the LAN and WAN by using appropriate LAN cables.
Note:
Before connecting the MG-SIP16 to network, be sure to execute “ping” command to
check the following:
- Is there other device having the same IP address overlapped?
- Is the new IP address assigned correct?
When you have finished, the following message appears on the Maintenance Console.
Note:
Both LAN1 and LAN2 must be connected to make MG-SIP16 online. (For a one-port configuration, only
LAN1 connection makes MG-SIP16 online.)
STEP 2: Check the lamp indication on the front panel of MG-SIP16.
- PWR lamp: lights green
- ON LINE lamp: lights green
20.4.6 Operation Check
When installation and necessary data assignment have been completed, perform the following operation tests.
STEP 1: Reboot the MG-SIP16 by using reboot command.
STEP 2: Make sure the following message appears on the Maintenance Console.
***************************************
* MG-SIP ONLINE START *
***************************************
***************************************
* MG-SIP ONLINE START *
***************************************
ATTENTION
Contents
Static Sensitive
Handling
Precautions Required
to LAN
to WAN
PWR ON
LINE
MG-SIP
FRONT
Ether2 Ether1