NEC SV8500, Manual

Page: 1836 / 3438

VOL.2-1583
MG-SIP128 [MG-128SIPMGJ]
• Registration by “set mp_data” command
Step8: To make this assignment effective, it is required to execute the “reboot” command to save
the configuration and restart the MG-SIP128 [MG-128SIPMGJ].
18.6.3 Registration by downloading CSV file
You can use a CSV file to add Connected Party number to the Multipoint Data Table. Upload and edit Multi-
point data file (mp_data.csv) on the TFTP server, and then download it to the MG-SIP, following the steps be-
low:
Step1: Access the configuration mode and upload the Multipoint data file (mp_data.csv) from the
MG-SIP.
MG(SIP)> upload
Enter “upload” in configuration mode.
--- Upload menu ---
Upload of mp_data file. --- input:1
Quit --- [Q/q]
Input:1
To upload CSVfile, enter “1”.
--- IP Address and Subnet mask
setting of MG(SIP) ---
Select Ether Port [1(Ether1)/2(Ether2)/
Q(quit)]:1 Select ether port.
(Be sure to use Ether1 port for default set-
ting. Assign 2 port by “set ipaddress” com-
mand for using Ether2 port.)
Current IP Address of MG(SIP):10.xx.x.xxx
Do you change IP Address of MG(SIP) ?
[Y(change)/N(current)/Q(quit)]:y To change IP address of the selected port,
enter “y”.
If you want to return to the previous step,
please input 'Q'.
Input new IP Address:172.yy.yyy.yyy Enter IP address.
Current Subnet mask of MG(SIP):255.0.0.0
Do you change Subnet mask of MG(SIP) ?
[Y(change)/N(current)/Q(quit)]:y To change Subnet mask of the selected port,
enter “y”.
If you want to return to the previous step,
please input 'Q'.
Input new Subnet mask:255.255.0.0 Enter Subnet mask.
--- IP Address setting of TFTP server ---