NEC SV8500, Manual

Page: 1778 / 3438

VOL.2-1525
MG-SIP128 [MG-128SIPMGJ]
(47) sip_domain
Setting of the SIP domain
This command is used to assign the SIP domain.
[Setting Example]
Note:
As with this command, SIP domain can be assigned by “set sip_server” command.
(48) sip_port_no
Setting of the port number that receives SIP messages
This command is used to specify a UDP port number that receives SIP messages.
[Setting Example]
Note:
Normally this command is not required to be changed.
(49) sip_qos
Setting of the ToS value for SIP signaling
This command is used to specify the ToS value of IP packets for SIP signaling.
[Setting Example]
* See “set drs_qos ” command for a display example and the contents of the configuration.
Note:
Normally this command is not required to be changed.
(50) sip_register
Setting of the information of SIP registrar
This command is used to assign an IP address or a Fully Qualified Domain Name (FQDN), and port num-
ber and expiration time of the SIP registrar.
The following figure shows an example of display.
When IP address (=0) is selected:
MG(SIP) > set sip_domain
Input Domain Name.(default=0,
MAX128(strings)):tokyo Input a SIP domain name in maximum of 128
characters.
MG(SIP) > set sip_port_no
Input SIP Port Number.
(1024-65535(default=5060)):5060 Assign the port number that receives SIP messages
(Default: 5060).
MG(SIP) > set sip_qos
MG(SIP) > set sip_register