NEC SV8500, Manual

Page: 1763 / 3438

VOL.2-1510
MG-SIP128 [MG-128SIPMGJ]
(26) ipx_rtp_port_no
Setting of the RTP base port number for LAN (Telephony Server network)
This command is used to assign the base port number that is used for RTP at LAN side. (Even numbers
only.)
[Setting Example]
Note: The conditions of this command are as follows.
• Normally this command is not required to be changed.
• RTP ports occupy 512 (128
×
4) ports (counting from the RTP base port number).
• If you select one port in the number of port setting (by “set ipaddress” command), be careful not to use the
same RTP port number (set by “set sip_rtp_port_no” or “set ipx_rtp_port_no” command) when setting the
non-default IPX network RTP base port number.
|Gateway Address|Destination network/Prefix
--------------------------------------------------
|10.1.0.254
|10.2.0.0 /16
Are you sure? Y/N=y
MG(SIP) > set ipx_route
Select Route type(0: Exit/1: None/2: Static): 2
Select command(0: Exit/1: Set/2: Delete): 1
Select Gateway type(0: Exit/1: Gateway/2: Default
Gateway):2
Input IP Address of Default Gateway:192.168.1.254
<< Result >>
Route type: Static
|Gateway Address|Destination network/Prefix
----------------+---------------------------------
|192.168.1.254 |0.0.0.0
/0
MG(SIP) > set ipx_rtp_port_no
Input IPX side RTP Port Number.
(1024-64000(default=51000)):51000 Assign the base port number that is used for
RTP at LAN side (Default: 51000).
(Receiving side of MG-SIP128 [MG-
128SIPMGJ])