NEC SV8500, Manual

Page: 1216 / 3438

VOL.2-963
MG-PRI/PRA
In SET command, some of the sub commands can be specified with hexadecimal numbers (called Set Value), which deter-
mine a group of the detailed values. It is also possible to omit its parameters; the interactive guidance will help you speci-
fying its detailed values. The following shows this patterns:
13.4.2 How to Read Maintenance Command in This Section
The commands in this section are explained with defined characters. These characters’ meanings are in the fol-
lowing:
CHARACTERS
MEANING
Δ
Blank
P1 , P2 , P3 Parameters
[ ] Parameter Option (indicates Not essential)
MG -PRI> SET TCS_E1_1
Dch Control ( 0/1:1 ): 1
Dch Mode ( 0/1:0 ): 0
Dch Signal Logic ( 0/1:0 ): 0
Dch-1 Drop/Insert ( 0/1:1 ): 1
Dch-2 Drop/Insert ( 0/1:0 ): 0
Drop/Insert Mode ( 0/1:0 ): 0
Data Transfer Speed ( 0-2:0 ): 0
Drop/Insert Time Slot ( 1-31:16 ): 16
Dch Signaling Set (0/1:0):0
set value is 0x9080
setting complete.
In order to make a setup reflect, re-starting is required
after saving a configuration file by SAVE command.
MG -PRI> SET TCS_E1_1 9080
set value is 0x9080
setting complete.
In order to make a setup reflect, re-starting is required
after saving a configuration file by SAVE command.
When the parameters are specified:
When the parameters are Not specified:
Set Value