NEC SV8500, Manual

Page: 1141 / 3438

VOL.2-888
MG(BRI) [SCA-2BRIA/MG-2BRIA]
12.4.7 Custom Mode
SET Command
1. SET DEFAULT_GATEWAY
Assign the IP address of Default Gateway.
Note:
Specify the Default Gateway in the same subnet of MG(BRI).
Note:
Execute the “SAVE” command before finishing the maintenance command to reflect change.
2. SET DHCP_SV
Assign whether to use DHCP Server or not.
Note:
Execute the “SAVE” command before finishing the maintenance command to reflect change.
3. SET DNS_IPADDRESS
Assign the IP Address of DNS server.
Note:
Enter 0.0.0.0 when DNS server is not used.
Note:
Execute the “SAVE” command before finishing the maintenance command to reflect change.
MG-BRI>set default_gateway P1
P1: IP address of Default Gateway
(default: 0.0.0.0)
Default configuration is ‘0.0.0.0’,
if you will not change a configuration by using this command.
In order to make a setup reflect and keep, re-starting is
required after saving a configuration data by SAVE command.
MG-BRI>set dhcp_sv
Input new DHCP Interface [E(enable)/D(disable)]:d
DISABLE=Not using DHCP server
ENABLE=Using DHCP server
Default configuration is ‘DISABLE’,
if you will not change a configuration by using this command.
In order to make a setup reflect and keep, re-starting is
required after saving a configuration data by SAVE command.
MG-BRI>set dns_ipaddress
IP Address: 10.41.1.150
Enter the IP address of DNS server
(default: 0.0.0.0)
e.g. 10.41.1.150
Default configuration is ‘0.0.0.0’,
if you will not change a configuration by using this command.
In order to make a setup reflect and keep, re-starting is
required after saving a configuration data by SAVE command.