NEC SV8500, Manual

Page: 1074 / 3438

VOL.2-821
MG(BRI) [SCA-2BRIA/MG-2BRIA]
12.3.4 Configuration Command Assignment
Assign the configuration data by command operation on maintenance console.
Note:
“SIP server” used in this section refers to the Telephony Server. The Telephony Server acts as SIP server
for MG(BRI) using SIP.
Note:
The setting data here is an example. Assign the network data adjusting to your network configuration.
STEP 1: Boot Program starts by turning the power ON or pressing RESET button on the front panel.
STEP 2: Press ESC key when the starting boot program message shown below appears.
Main menu of boot mode is displayed and configuration command entry is available on the mainte-
nance console.
STEP 3: Enter “1” after [Input:] then press Enter key.
STEP 4: Main menu of the configuration mode appears. Enter “1”
after [Input:] then
press Enter key to start
Standard mode.
Note:
Configuration command has two modes; Standard mode and Custom mode. Use Standard mode when start-
ing up MG(BRI) for the first time to assign the basic data for connecting network. See
Section 12.4.5 How
to Use Maintenance Command for the detailed information of each command.
STEP 5: Assign whether DHCP server and DNS server are used or not.
(1) DHCP server enable/disable setting
(2) DNS server enable/disable setting
Starting MG-BRI boot program...
-<Boot mode>Main menu-
Configuration data.
Quit
Input: 1
--- input: 1
--- [Q/q]
-<Configuration mode>Main menu-
Standard
Custom
Quit
--- input: 1
--- input: 2
--- [Q/q]
Input: 1
--- DHCP Interface set ---
Current DHCP Interface: DISABLE
Change DHCP Interface? [Y (change)/N (current)/Q (quit)]: y
Input new DHCP Interface [E (enable)/D (disable)]: e
--- DNS Interface set ---