16
2. Projecting an Image (Basic Operation)
3. Press the
(POWER) button on the projector cabinet
or the POWER ON button on the remote control.
WARNING
The projector produces a strong light. When turning on
the power, operate from the side or rear of the projector
(outside the Restriction Zone (HD)). Also, when turning
on the power, make sure no one within the projection
range is looking at the lens.
The
POWER indicator goes from a steady green light to
a flashing blue light, and the picture is projected on the
screen.
After you turn on your projector, ensure that the computer
or video source is turned on.
NOTE:
• The blue screen ([BLUE] background) is displayed when no signal
is being input (by factory default menu settings).
Standby
Blinking
Power On
Steady green light
Blinking blue
light
Steady blue
light
Performing Lens Calibration
After installation or replacement of the lens, be sure to perform
[CENTER LENS] by pressing and holding the HOME button
on the projector cabinet for at least two seconds or by hold-
ing the CTL button and pressing the INFO/L-CALIB. button
on the remote control. Perform [CENTER LENS] also when
trouble is found on the lens shift motion. Calibration corrects
the adjustable lens shift range. Also, perform [CENTER LENS]
when an error occurs in the lens shift operation. (
→
)
