4-10 Installing Options
Locating Expansion Slots and Connectors
The following figure shows the locations of the expansion slots on the
chassis and the expansion board connectors on the system board.
Locating expansion board slots and connectors
A – PCI Expansion Board Connectors
C – AGP Board Connector
B – PCI Expansion Board Slots
D – AMR Board Connector
Removing the Retainer Bar
Expansion boards and slot covers are held in place by a retainer bar.
Remove the retainer bar as follows.
1.
Remove the cover (see “Removing the Cover” earlier in this chapter).
2.
Press down on the two tabs on the retainer bar to release the tabs
from their slots. Carefully remove the bar from the chassis (see the
following figure).
3.
If you are removing an expansion board, see “Removing an
Expansion Board.” If you are adding an expansion board, see
“Replacing an Expansion Board.”
4.
To replace the bar, see “Replacing the Retainer Bar” later in this
chapter.