24
2. Projecting an Image (Basic Operation)
Focus
NOTE:
• For lens unit NP-9LS08ZM1, both central and peripheral focus must be adjusted. Use th/−buttons to adjust the central
focus. If the peripheral focus is off, contact your dealer to have them adjust it.
1. Press the FOCUS +/− button.
• On the remote control, while pressing on the CTL button, press on VOL/FOCUS (+) or (−) button.
The focus is adjusted.
TIP: To obtain the best focus, perform the following (for fixed installation)
Preparation: Warm up the projector for one hour.
1. Use the FOCUS +/− buttons to make sure you obtain the best focus. If you do not, move the projector back and forth.
2. Select the [TEST PATTERN] from the menu and display the test pattern. (
→
page
)
• You can also use the TEST button on the remote control to display the test pattern.
3. Keep pressing the FOCUS − button until the grid of the text pattern is made invisible.
4. Keep pressing the FOCUS + button until you obtain the best focus.
If you adjust beyond the best focal point, go back to step 3 and repeat the procedures.
Zoom
1. Press the ZOOM +/− button.
• On the remote control, while pressing on the CTL button, press the D-ZOOM/ZOOM (+) or (−) button.
The zoom is adjusted.
