NEC PA1004UL-W, User Manual

Page: 174 / 240

5. Using On-Screen Menu
150
[SOURCE OPTIONS]
Setting Auto Adjust [AUTO ADJUST]
This feature sets the Auto Adjust mode so that the computer signal can be automatically or manually
adjusted for noise and stability. You can automatically make adjustment in two ways: [NORMAL]
and [FINE].
OFF The computer signal will not be automatically adjusted. You can manually optimize the computer
signal.
NORMAL Default setting. The computer signal will be automatically adjusted. Normally select this option.
FINE Select this option if fine adjustment is needed. It takes more time to switch to the source than when
[NORMAL]is selected.
TIP:
• The default setting when shipped from the factory is [NORMAL].
[AUDIO SELECT]
This selects the audio input of the HDMI 1 IN terminal, HDMI 2 IN terminal, DisplayPort IN terminal
and HDBaseT IN/Ethernet port.
Selecting Default Source [DEFAULT INPUT SELECT]
You can set the projector to default to any one of its inputs each time the projector is turned on.
LAST Sets the projector to default to the previous or last active input each time the projector is turned on.
AUTO Searches for an active source in order of HDMI1
→
HDMI2
→
DisplayPort
→
COMPUTER
→
HDBaseT and displays the first found source.
HDMI1 Displays the digital source from the HDMI 1 IN connector every time the projector is turned on.
HDMI2 Displays the digital source from the HDMI 2 IN connector every time the projector is turned on.
DisplayPort Displays the digital source from the DisplayPort every time the projector is turned on.
COMPUTER Displays the computer signal from the COMPUTER IN connector every time the projector is turned
on.
HDBaseT Project the HDBaseT signal.
[SEAMLESS SWITCHING]
When the input connector is switched, the image displayed before switching is held to switch to
the new image without a break due to absence of a signal.