23
3. Projecting an Image (Basic Operation)
Selecting a Source
Selecting the computer or video source
NOTE: Turn on the computer or video source equipment connected to the projector.
Selecting from Source List
Press and quickly release the SOURCE button on the projector cabinet to dis-
play the Source list. Each time the SOURCE button is pressed, the input source
will change as follows: “COMPUTER1”, “COMPUTER2”, “COMPUTER3”, “VID-
EO”, “S-VIDEO”. To display the selected source, allow 1 second to elapse.
Detecting the Signal Automatically
Press and hold the SOURCE button for a minimum of 2 seconds, the projector
will search for the next available input source. Each time you press and hold the
SOURCE button for a minimum of 2 seconds, the input source will change as
follows:
COMPUTER1
→
COMPUTER2
→
COMPUTER3
→
VIDEO
→
S-VIDEO
→
COMPUTER1
→
...
TIP: If no input signal is present, the input will be skipped.
Using the Remote Control
Press any one of the COMPUTER 1/2/3, VIDEO, and S-VIDEO buttons.
Selecting Default Source
You can set a source as the default source so that it will be displayed each time
the projector is turned on.
1. Press the MENU button.
The menu will be displayed.
2. Press the
button twice to select [SETUP] and press the
button or
the ENTER button to select [GENERAL].
3. Press the
button four times to select [OPTIONS(2)].
4. Press the
button six times to select [DEFAULT SOURCE SELECT] and
press the ENTER button.
The [DEFAULT SOURCE SELECT] screen will be displayed.
(
→
page
5. Select a source as the default source, and press the ENTER button.
6. Press the EXIT button a few times to close the menu.
7. Restart the projector.
The source you selected in step 5 will be projected.
TIP: When the projector is in Standby mode, applying a computer signal from a computer
connected to the COMPUTER 1 IN or COMPUTER 2 IN input will power on the projector
and simultaneously project the computer’s image.
([AUTO POWER ON(COMP1/2)]
→
page
)
