DOD-PD-1261 (2nd edition)
5
2.3 REPLACEMENT
Refer to the Fig.1 and Fig.2.
(1) Put on the fingerstalls and attach the grounding band.
(2) Turn
the
ionizer switch on.
(3) The LCD module should be kept turned off, and wait for a while until the backlight get cool down
enough.
(4) Put the LCD module display side up on the flat workbench, which is equipped for static charge
prevention.
(5) Pull out the lamp cable plug from lamp connector in Figure. Do not fold the high voltage cable as
sharp folds can cause permanent damage.
(6) Release the lamp holder from clamped portion
A
in figure 2 pushing up portion
A
.
(7) Slowly, gently and in a straight line pull out the lamp holder in the direction of the arrow
B
in
figure 2. If the lamp was broken inside of backlight lamp, carefully pull out the lamp holder. If
pieces of glass remain inside the enclosure, carefully remove them.
(8) Slowly, gently and in a straight line push in the lamp holder in the direction of the arrow
C
and
lock portion
A
in figure 2.
(9) Replace the lamp holder. The up side lamp holder is the same as down side.
(10) Fix the lamp holder through the clamp position
A
in figure 2.
(11) Replace the lamp holder is possible to set in the upper side lamp and the lower side.
3. DISPOSAL OF THE LAMP HOLDER
The lamp holder includes cold cathode fluorescent lamps. Follow local ordinances or regulations for its
disposal.
Do not reuse the replaced
lamp holder set
.
