English-13
Installation of adapter for wireless LAN unit
Depending on the model of the display, when an external speaker is fitted, the wireless LAN unit may
interfere with the external speaker, making direct connection to the product impossible. In this case, use
an adapter for the wireless LAN unit (hereinafter “adapter”) and a USB extension cable to install the wireless
LAN unit to the back of the display etc.
1. Install the adapter such that the indicator on the wireless
LAN unit is on the side of the screw holes on the adapter.
Indicator
Screw hole
2. Securely fasten the adapter with the enclosed adapter screws.
(tightening torque 19.6N•cm - 29.4N•cm)
CAUTION:
• Do not apply a force higher than the specified force when
tightening the screws. This may result in damages to the screw
holes.
3. Connect the USB extension cable to the USB Port of the product and the USB port of the wireless LAN unit.
4. Peel off the cover of the two-sided tape at the bottom of the adapter and press it strongly against the rear of
the display to secure the adapter.
CAUTION:
• Secure the adapter only after you have carefully considered the installation position.
• Install the adapter on a horizontal surface.
• Install the adapter in a location that will not impose stresses on the USB extension cable.
• Do not install the adapter on top of the heat release outlet on the display.
• Remove all moisture, dust, oil, etc., from the location first before pasting the adapter at the location. Do not allow the
sticky surface to get into contact with your hands or dust. This will result in a drop in the adhesive strength.
• The two-sided tape cannot be peeled off and used again. Do not use it again once it is peeled off.
• Be careful when removing an adapter that has been attached using two-sided tape. Using excessive force may result in
damages to the adapter.
