NEAX2400 IPX Feature Programming Manual
Page 380
NDA-24297, Issue 1
H-2
House Phone
H-2 House
Phone
General Description
This feature allows selected stations to reach the ATTENDANT CONSOLE [A-1] by going off-hook.
Operating Procedure
To reach the ATTENDANT CONSOLE [A-1]:
1.
The HOUSE PHONE user lifts the handset. The Attendant is called automatically.
2.
The Attendant answers.
3.
The Attendant connects the user to the desired station or trunk.
Service Conditions
1.
Attendant Console indications will appear as follows:
a.) ATND lamps flash
b.) Console buzzer sounds.
2.
HOUSE PHONES may be equipped with or without dials.
3.
HOUSE PHONE assignments are programmed into system data via the MAINTENANCE
ADMINISTRATION TERMINAL (MAT) [M-18].
4.
There is no limit to the number of HOUSE PHONES permitted in the system.
Interactions
1.
The AHLS command is not needed. When a station is programmed as TEC: 14, HOTLINE, it will
automatically be connected to the Attendant Console.
2.
If the House Phone is to be used for outgoing calls via the Attendant Console (ARSC command RRI 2),
assign a Route Restriction Class that will allow these connections. The same consideration should be made
for Incoming calls via the Attendant Console (RRI 0).
Programming
ASDT
- Assign the station as a TEC = 14 for HOTLINE.
FCCS Programming
No unique programming is required for the FCCS network.