NEC NEAX 2400 IPX, Programming Manual

Page: 88 / 316

CHAPTER 5 NDA-24305
Page 70
Revision 1.0
DATA INTERFACE-AUTOMATIC ANSWER-PRI
D-119 DATA INTERFACE-AUTOMATIC ANSWER-PRI
1. General Description
This feature enables incoming ISDN Data Calls to be answered automatically by a D
term
/Data Adapter.
2. Operating Procedure
To set DATA INTERFACE AUTOMATIC ANSWER-PRI, select the Attribute Data Entry or change the switch
setting for Auto Answer. Refer to ATTRIBUTE DATA ENTRY [A-39] for details.
The D
term
/Data Adapter may be set in two ways:
Setting the D
term
Data Adapter for Auto Answer by changing the Terminal Attribute Data II
1. Press the “DATA” key; The DATA lamp lights steadily and the display shows 'D'.
2. Press the “DTX” key (or “ANSWER” key). The “DTX” lamp (or ANSWER lamp) lights steadily.
3. The display shows 'DATA SET'.
4. Key in '00'; the display shows 'ER CHECK XX YY'; press the “#” key.
5. The display shows 'AUTO ANS 01 YY'.
6. Key in '01'; the display shows 'AUTO ANS 01 01'.
7. Press the “#” key, and Service Set Tone (2 beeps) is heard; press the “DATA” key.
8. Auto Answer Setup is complete.
Setting the D
term
Data Adapter for Auto Answer by pressing the “DSPY/AUTO” key:
1. Press the “DSPY/AUTO” key. The “DSPY/AUTO” lamp lights steadily.
2. Auto Answer Setup is complete.
Note:
ER=DTR
3. Programming
STEP 1: ARSC - Allow the restriction for an incoming call from ISDN trunk (Bch).
STEP 2: ASDT - Assign an Data Terminal (DTE).
TEC=13 (Data Terminal via Data Adaptor)
TEC=16 (Data Terminal via Data Module)
STEP 3: AKYD - Assign the Data key on D
term
.
FKI=1, FKY=29 (DATA)
FKI=1, FKY=30 (DSPY/AUTO)
FKI=1, FKY=31 (DTX)