NEC NEAX 2400 IPX, Programming Manual

Page: 67 / 316

NDA-24305 CHAPTER 5
Page 49
Revision 1.0
CALL TRANSFER-ATTENDANT-PRI
C-98 CALL TRANSFER-ATTENDANT-PRI
1. General Description
This feature permits a station user, while connected to an ISDN network call, to signal the Attendant and have
the Attendant transfer the call to another station within the system.
2. Operating Procedure
Calling the Attendant:
1. While engaged in a PRI trunk call, press the switchhook; receive Special Dial Tone.
2. Dial the operator/access code.
3. a. ATTENDANT CONSOLE [A-3] “RCL” lamp flashes and buzzer sounds.
b. The station receives Ringback Tone.
Answering by the Attendant:
1. Refer to “ATTENDANT CONSOLE USER’S GUIDE”.
If the station wishes to return to the Central Office trunk call while the Attendant is being called:
1. Press the switchhook; the “RCL” lamp goes out; the buzzer stops.
2. Ringback Tone stops; the station returns to PRI trunk call.
3. Programming
STEP 1: ASYD - System Data 2, Index 1, bit 0 and 1: Assign a data to allow CONSULTATION HOLD. All
types of connections.
STEP 2: ATNR - Allow tenant restriction. Assign Tenant Restriction Index (TRI) 0, and 4 on an intra-and
Inter-tenant basis.