NEC NEAX 2400 IPX, Programming Manual

Page: 173 / 316

NDA-24305 CHAPTER 5
Page 155
Revision 1.0
TOLL DENIAL/TOLL DIVERSION-PRI
T-40 TOLL DENIAL/TOLL DIVERSION-PRI
1. General Description
This feature prohibits station users from placing long distance calls over specific ISDN network trunks.
Restricted calls are routed to either an ATTENDANT CONSOLE [A-3] (diversion) or to an Reorder Tone
(denial).
2. Operating Procedure
No manual operation is required.
3. Programming
STEP 1: ASYD - System Data 1, Index 75: Should the following commands be developed for
Day/Night: 0/1: No/Yes. See DAY/NIGHT
CLASS OF SERVICE [D-15] for details.
-Bit 0- Develop ARSC command for Day/Night?
-Bit 3- Develop ATDP command for Day/Night?
System Data 2, Index 1, bits 4 & 5: If TOLL DENIAL is required, assign these bits
as data “00”. If TOLL DIVERSION is required,
assign these bits as “01”. Calls are then diverted
to the Attendant Console. Assigned on a per-
tenant basis.
STEP 2: ARSC - Assign Route Restriction Classes. When these are assigned to stations, classes will
determine whether or not a station will be allowed access to a specific route or specific
dialing sequence. See TOLL RESTRICTION-3/6 DIGIT [T-7]. Assign the following:
DAY/NIGHT:
Day/Night Mode
D: Day Mode
N: Night Mode
TN: Tenant Number
RT: Route Number
RSC: Route Restriction Class
RRI: Route Restriction Index
0-IC Restriction via Attendant Console/station
1-IC Restriction Direct Connection
2-OG Restriction via Attendant Console/station
3-OG Restriction Direct Connection
RES: Restriction Data
0-Connection is Restricted
1-Connection is Allowed
2-Connection is Toll Restricted (See “TOLL RESTRICTION-3/6-DIGIT”, [T-7])
STEP 3: ASDT - When assigning the data to specific stations, assign the proper RSC to each station.