78
6. Appendix
6-6. Specifications
Model name
NC3541L
Projection method
3 chip DLP Cinema® method
1.38-inch DC4K chip
Panel resolution
4096 x 2160
Light source
Laser Diode
Screen sizes
Max. 32 m @14ft-L / Screen Gain 2.6 (Depends on setup conditions)
Contrast ratio
2000:1 with DCI specified color representation
Lens adjustment function
Motorized lens shift (vertical/horizontal), motorized zoom, motorized focus
Signal input ports (slot)
When shipped from factory: Empty
(for mounting optional components) (Note 1)
External Control
RS-232C (D-sub 9pin) x 1
GPIO port (D-sub 37 pin) x 1
Service terminal (stereo mini jack) x 1
3D CTL (D-sub 15 pin) x 1
USB (Type A) x 1
Remote interlock port x 1
Ethernet port (RJ-45) x 1
Power supply voltage
For C1 connection (Note 3) :
Single phase AC 200V-240V 50/60Hz (projector power light power supply)
For C2 connection (Note 3) :
Single phase AC 200V-240V 50/60Hz (projector power supply)
Single phase AC 200V-240V 50/60Hz (light power supply)
Input current
For C1 connection (Note 3)
projector power light power supply: 30.0A
For C2 connection (Note 3)
projector power supply: 4.9A
light power supply: 25.1A
Power consumption (Note 2)
For C1 connection (Note 3)
projector power light power supply: 4885W
For C2 connection (Note 3)
projector power supply: 885W
light power supply: 4000W
Cooling method
Cooling fluid system, Cooling air system
Noise level
Less than 55 dB
Installation
Orientation: Desktop/front, Desktop/rear, Ceiling/front, Ceiling/rear
Net weight
169 kg (Excluding lens)
Dimensions
697 mm (W) x 1180 mm (D) x 455 mm (H) (Does not including protruding portions, includes foot.)
Environment
Operating temperature: 10 to 35°C
Operating humidity: 10 to 85% (non-condensing)
Storage temperature: -10 to 50°C
Storage humidity: 10 to 85% (non-condensing)
Operating altitude: 0 to 2600m/8500 feet
(Note 1) The video input slots are empty when the device is shipped. Input ports can be added by mounting option boards, which
are sold separately. (See page 87)
(Note 2) The value is typical.
(Note 3) C1 connection is the case when the AC power to the projector power supply and the light power supply is provided by a
single cable.
C2 connection is the case when the AC power to the projector power supply and the light power supply is provided by sepa-
rate cables.
* Described the certification standard for laser products in “Important Information” of this manual. (See page 2)
* Note that these specifications and design can change without prior notice.
