- 8 -
2022 April(1
st
Edition)
2.4. Setting up LAN drivers
Important
・
Sign in the system by administrator account for execute the operation below.
・
After changing parameters of the LAN driver, restart the system.
・
N8104-213/215/217/219 are LAN boards of 1000BASE-T/10GBASE-T
specification.Switching hubs and LAN ports of 100BASE-T, which have
mismatched specifications, are not supported as destinations. Use the
1000BASE-T/10GBASE-T switching hub and LAN port to which the
specifications match.
・
For Speed & Duplex settings, be sure to use Auto Negotiation.
"1.0 Gbps Full Duplex" and "10 Gbps Full Duplex" are not supported.
2.4.1.
Flow Control
It is necessary to set the Flow Control parameter of the network adapter matching to the
connected network equipment (switching hub etc.).
Please set Flow Control parameter by the following procedures.
Note
The settings of Flow Control of the network adapter should match those of the
destination device.
For example, if Flow Control in the destination device is set as Enabled, that in the
network adapter should be set as Enabled.
1. Open
Device Manager
.
2. Expand
Network adapters
, and then double-click the network adapter you want to set. The
properties of the network adapter will be displayed.
3. Open
Advanced
tab and click
Flow Control
to show
Value
.
4. The value can be configures by the down-arrow button.
5. Click
OK
in the network adapter properties dialog box.
