57
6. Network control
❶
Network control operation
Function: This function is designed to remote control computer in the same LAN.
Preparation
1. Required equipment: Projector, Computer, Network cable
2. Connection:
Connect your projector to a router or switch in the LAN with normal or jumper network cable. In case a normal net-
work cable failed to connect successfully, use a jumper cable instead.
3. Turn on the computer. The LAN port on computer and projector are flashing after power on the projector.
Operation steps
1. Power on your projector.
2. Acquire the IP address, with DHCP set to on and auto IP allocation set to On. (You may set DHCP to Off and set
up IP address manually if you are somehow familiar with networking.)
3. Enter the network setup menu
(1) Press MENU button on remote controller or top control panel, press
button to select LAN icon.
(2) Press ENTER button or button and the network menu displays.
(3) Press
button select network settings and press ENTER to confirm.
(4) Press
button to set DHCP On and press ENTER button to confirm.
(5) Press
button to select Set, press ENTER button to wait until the “Please wait..” message disappears.
7C:6F:F8:4E:B9:2F
192.168.1.100
Expand
Network Setup
Network setting
Network information
MAC address:
IP address
：
Move
Wired LAN
Wireless LAN
DHCP
IP address
Subnet
Gateway
DNS
Setting
Set
On
On
Cancel
Set
Cancel
. . .
. . .
. . .
. . .
：
Next
ENTER
：
Back
EXIT
：
Move
：
Next
：
Back
Wired LAN
Wireless LAN
DHCP
IP address
Subnet
Gateway
DNS
Setting
off
On
Cancel
Set
ENTER
EXIT
192 . 168 . 1 . 1
255 . 255 . 255 . 0
192 . 168 . 1 . 1
0 . 0 . 0 . 0
NOTE:
• If you are using the wireless LAN connection, please check the SSID / ESSID and wireless IP address in the network setting status , and
write down the information.
