129
6. Installation and Connections
Prepare a Phillips screw driver beforehand.
1. Press the POWER button to turn off the projector and set it
into standby condition, and disconnect the power cord.
2. Remove the USB (LAN) port cover.
Loosen the screw securing the port cover.
• The screw is not removable.
3. Slowly insert the USB Wireless LAN Unit into the USB (LAN)
port.
Remove the cap from the USB Wireless LAN Unit, and then insert
it with the surface (side of indicator) facing outward. Keep the cap
for later use.
NOTE: Do not force to insert the USB Wireless LAN Unit.
4. Put the USB (LAN) port cover back into place.
Insert the catch of the USB (LAN) port cover into the groove of the
projector cabinet, and then tighten the screw to secure the port
cover.
To remove the USB Wireless LAN Unit, disconnect the power cord
and use the above procedure.
NOTE:
• The green LED on the USB Wireless LAN Unit flashes to show that Wireless
LAN Unit is working. If the USB Wireless LAN Unit is incorrectly attached,
the blue LED will not flash.
• Do not press the button on the USB Wireless LAN Unit. The button will not
work with this model.
