-63-
4.5.5
Setting of I/O Station
You can configure the library unit to use a part of the front magazine as I/O station. Described
below is the setting procedure.
1)
[Login]. See Section 4.3Login for detail.
2)
Select [Configuration]
3)
Select [Library Settings] from [Configuration].
4)
Select [Enable] of [I/O station] from [Library Settings].
5)
Selecting [Apply], the port of the drive is reset,and the setting is applied.
4.5.6
Setting of Active Slot
You can change the number of slots logically in the library unit. Described below is setting
procedure.
1)
[Login]. See Section 4.3Login for detail.
2)
Select [Configuration].
3)
Select [Library Setting] from [Configuration].
4)
Select [Active Slots] from [Library Settings].
5)
The following screen will appear.
6)
Input number of Active slots.Select [Yes] to set change number of Active slots.
7)
Selecting [Apply], the port of the drive is reset,and the setting is applied.
If I/O Station is enabled
：
If the I/O station is enabled, two decreases of the number of slots that can be set.
The number that can be set as Active Slots is only the even numbers.