NEC ELECTRA ELITE IPK II, Features And Specifications Manual

Page: 263 / 996

Electra Elite IPK II Document Revision 1
Cordless Telephone Connection 2 - 241
Cordless Telephone Connection
Description
Using an AP(R)/AP(A)-R Unit for a DTH/DTR telephone, or an APR/APA-U Unit for a DTU/DTP
telephone, a cordless telephone (2500-type) can be connected to a Multiline Terminal.
The SLI(4)/(8)-U( ) ETU and the SLT(1)-U( ) ADP also supports cordless telephones, but this feature
refers to Multiline Terminal cordless connection.
Conditions
A voice announced internal call to the Multiline Terminal does not ring the cordless
telephone.
Only one cordless Single Line Telephone can be connected to an APR-U, APA-U, AP(R)-R,
or AP(A)-R Unit.
When CO Prime Line is assigned to the associated Multiline Terminal, internal dial tone
cannot be transferred to the cordless telephone.
The cordless telephone requires a PBR circuit while dialing. When all PBR circuits are
busy, a busy tone is heard when the phone goes off-hook.
Depending on your environment, the maximum number of cordless devices used without
interference varies.
This feature works with 2500-type cordless Single Line Telephones.
The Multiline Terminal user and the associated cordless telephone user cannot talk to each
other.
An AP(A)-R, AP(R)-R, APA-U, or APR-U Unit with hookflash enabled follows the same
operating procedures as a Single Line Terminal connected to an SLI(8)-U( ) ETU.
The Multiline Terminal LCD displays normal information for Multiline Terminal when a
cordless terminal is used.
When the Multiline Terminal user goes off-hook before the cordless Single Line Telephone
user, a PBR circuit is not connected for the cordless Single Line Telephone.
The ring pattern for the cordless telephone can be selected by a jumper switch in the
AP(R)-R or APR-U Units. The patterns are:
J 1 second ON/2 seconds OFF
J
2 seconds ON/4 seconds OFF
The cordless telephone must be installed within 10 feet of the AP(R)-R Unit or APR-U Unit.